Enmet CD-1300-ST Manual de usuario

ENMET Corporation PO Box 979 Ann Arbor, MI 48106-0979 www.enmet.com Manual Part Number 80003-134 MCN-13-004, 06/24/13

CO2 Sensor / Transmitter ENMET Corporation 8 6.0 Duct Sampling Option Figure 3: Duct Sampling Schematic 6.1 Overview The duct sampling option is

CO2 Sensor / Transmitter ENMET Corporation 9 7.0 WARRANTY ENMET warrants new instruments to be free from defects in workmanship and material und

CO2 Sensor / Transmitter ENMET Corporation 1 PO Box 979 680 Fairfield Court Ann Arbor, Michigan 48106-0979 734.761.1270 Fax 734.761.3220 Retu

Repair Return Form Mailing Address: ENMET Corporation PO Box 979 Ann Arbor, Michigan 48106 Phone Number: 734.761.1270 FAX Number: 734.

Table of Contents 1.0 INTRODUCTION ...

CO2 Sensor / Transmitter ENMET Corporation 1 1.0 Introduction The CD-1300-ST Series Sensor/Transmitter (S/T) are a non-dispersive infrared analyze

CO2 Sensor / Transmitter ENMET Corporation 2 2.0 Features 2.1 Display and Indicators The basic CD-1300-ST Series has a single green LED on the f

CO2 Sensor / Transmitter ENMET Corporation 3 3.0 Installation Figure 1: CD-1300-ST Series, Mounting Dimensions 3.1 Removal of Cover To open the

CO2 Sensor / Transmitter ENMET Corporation 4 3.3.1 Power supply The CD-1300-ST series will operate from an AC or DC input voltage between the val

CO2 Sensor / Transmitter ENMET Corporation 5 4.0 Field Adjustments This section describes the features that can be field configured and the proce

CO2 Sensor / Transmitter ENMET Corporation 6 4.2 Altitude Correction The CD-1300-ST series is factory-calibrated for operation at sea level. Whe

CO2 Sensor / Transmitter ENMET Corporation 7 To verify the CD-1300-ST Series's calibration, proceed as follows: *NOTE: For instruments with