Enmet EX-2000 Manual de usuario descargar pdf (Pagina 15)

EX2000 ENMET Corporation

4.3 Replacing the EX-2000 Sensor

The EX-2000 is equipped with a catalytic sensor with a microprocessor source.

Being a vital element of the gas detector, the sensor module must be treated with care. Mechanical impacts, splashing with

water etc… may impair the quality of the measurement or even, in extreme cases destroy the sensor.

A water-repellent and anti-dust filer fixed to the sintered metal protects the head of the sensor.

To replace the sensor and filter:

 Remove sensor cover by unscrewing the sensor cover from the instrument.

 Note the placement of the cover seal, filter and sensor seal.

 Unplug sensor and remove.

 Plug-in the new sensor.

 Replace sensor seal, filet and cover seal

 Replace sensor cover and screw into instrument.

Figure 2: Sensor Located under the Sensor Cover

5.0 Replacement Part Numbers

5.0 Replacement Part Numbers5.0 Replacement Part Numbers

5.0 Replacement Part Numbers

ENMET replacement part numbers:

Description Part Number

Programming Plug 02552-005

Calibration cup 02552-004

Sensor 02552-001

Sensor Filter 02552-003

Battery pack with plug 02552-012

Charger, 110Vac 67051-050

Charger, 220Vac 67051-051

Sensor Cover

Filter

Sensor

Sensor Seal

EX-2000 Instrument

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Enmet EX-2000 Manual de usuario Pagina 15