Enmet SPECTRUM SP Manual de usuario

ENMET Corporation PO Box 979 Ann Arbor, MI 48106-0979 Manual Part Number 80012-018 MCN-428, 12/23/09 SPECTRUM SP Series

SPECTRUM SP Series ENMET Corporation 8 3.1.1 Key Entrance to the maintenance menu is guarded with a four digit numerical key. The factory defaul

SPECTRUM SP Series ENMET Corporation 9 3.1.4 Changing the Alarm Level A valid key entry sets the instrument at the "run ZERO" location

SPECTRUM SP Series ENMET Corporation 10 3.2 Changing Components Changing the battery, the sensor, or the display requires that the back cover of

SPECTRUM SP Series ENMET Corporation 11 3.2.2 Battery Removal and Replacement The battery is located under the circuit board. To replace the batt

SPECTRUM SP Series ENMET Corporation 12 4.0 Replacement Parts and Accessories ENMET part numbers for replacement parts and accessories: Calibrati

SPECTRUM SP Series ENMET Corporation 13 5.0 WARRANTY ENMET warrants new instruments to be free from defects in workmanship and material under nor

SPECTRUM SP Series ENMET Corporation 14 Appendix A: Calibration Data Tables Table 1: Gas Ranges, Alarm Points and Sensor Life Gas Range Alarm

SPECTRUM SP Series ENMET Corporation 15 Table 2: SPECTRUM SP Calibration Voltage and Countdown Times NOTE: The following are values used for pro

SPECTRUM SP Series ENMET Corporation 16 APPENDIX C SPECTRUM SP for Hydrazine SPECTRUM SP For Hydrazine The detection of hydrazine, N2H4, is a sp

PO Box 979 680 Fairfield Court Ann Arbor, Michigan 48106-0979 734.761.1270 Fax 734.761.3220 Returning an Instrument for Repair ENMET instrumen

Table of Contents 1.0 INTRODUCTION ...

Repair Return Form Mailing Address: ENMET Corporation PO Box 979 Ann Arbor, Michigan 48106 Phone Number: 734.761.1270 FAX Number: 734.

SPECTRUM SP Series ENMET Corporation 1 1.0 Introduction The SPECTRUM SP is a small portable battery operated single channel gas detection instrum

SPECTRUM SP Series ENMET Corporation 2 1.2 Turn Instrument ON Turn the instrument ON, by pressing and holding the POWER / BACKLIGHT pushbutton fo

SPECTRUM SP Series ENMET Corporation 3 Figure 1: SECTRUM Features ChargeJackAlarmPowerRed: Battery ChargingSelectGreen: Battery chargerOptionCo

SPECTRUM SP Series ENMET Corporation 4 2.1 Operation 2.1.1 Operational Menu The operation menu flow diagram is shown in Figure 2. This menu is a

SPECTRUM SP Series ENMET Corporation 5 2.1.2 Turn ON and OFF Turn the instrument ON by pressing the POWER / BACKLIGHT pushbutton for two seconds.

SPECTRUM SP Series ENMET Corporation 6 2.1.6 Battery Status and Low Battery Alarms The battery status display is accessed by pressing the OPTION

SPECTRUM SP Series ENMET Corporation 7 3.0 Maintenance 3.1 Maintenance Menu From the operational display, press the OPTION pushbutton four times;