
ENMET Corporation ISA-44-2-OD
22
6.0 Replacement Part Numbers6.0 Replacement Part Numbers
ENMET replacement part numbers:
Description Part Number
Explosionproof Sensor 03033-109
Explosionproof Sensor 03033-812
Explosionproof Sensor 03033-813
Replacement Oxygen Cell 67013-008
Replacement lens, Red ½″
62012-011
Replacement lens, Green ½″
62012-012
Replacement lens, Amber ½″
62012-013
Replacement Lamp ½″
63001-002
Replacement lens, Red 1″
62012-001
Replacement lens, Green 1″
62012-002
Replacement lens, Amber 1″
62012-003
Replacement, LED Red 1″
52006-003
Replacement, LED Green 1″
52006-001
Replacement, LED Amber 1″
52006-002
Replacement Oxygen Cell, PCB 03258-012
Cylinder of Calibration Gas Contact ENMET for part number of
target gas for each instrument.
See note below.
NOTE: The gases should be identical, or equivalent (correlation gas) to those used to initially calibrate the unit, unless
you want to recalibrate to a new gas or different concentration. In addition, calibration gases must be in a
background of air; do not use gases with an inert gas background (such as nitrogen or argon).
7.0 Specifications7.0 Specifications
These are general characteristics; actual specifications will vary according to custom-built features, boxes, etc.
Power
• 115 +/- 10% VAC single phase
• 220 VAC single phase, 50-60 Hz, 40 watts
• 12 VDC, 40 watts
Relay Current 5 amps, non-inductive surge, 2 amps steady
Sensor Life Up to 3 years in fresh air
Oxygen Average 14 months, 6 month warranty
Electronics Low power, all solid-state with integrated circuits.
Audio Alarm 2900 Hz, 95 dB at 21 feet
Enclosure NEMA-4X box, watertight, oiltight, corrosion proof (optional NEMA-12 steel or
stainless steel box).
Size 18" tall x 14.5" wide x 8" deep
Weight 48 lbs. (including cables, sensor housing, horn, etc.).
NOTE: All specifications stated in this manual may change without notice.
Comentarios a estos manuales