Enmet RECON/B SERIES Manual de usuario Pagina 1

ENMET PO Box 979 Ann Arbor, MI 48106-0979 www.enmet.com Manual Part Number 80006-023 MCN-14-006, 09/30/14 RECON/B

RECON/B SERIES ENMET 8 5.0 Maintenance of the RECON/B SERIES To maintain proper battery function and life the Recon should be operated once a wee

RECON/B SERIES ENMET 9 5.1.3 Calibration Point Adjustment In this mode, display is the last concentration of gas used to calibrate the instrument

RECON/B SERIES ENMET 10 5.2 Alarm Levels Adjustment of the RECON/B SERIES 5.2.1 Set up of L-alarm (Low Alarm) With the RECON/B SERIES Off press a

RECON/B SERIES ENMET 11 5.4 Sensor Replacement Sensor life in the RECON/B SERIES is typically: 2 years for Carbon Monoxide & Hydrogen Sulfide

RECON/B SERIES ENMET 12 7.0 Accessories and Replacement Parts 7.1 Replacement Sensor part numbers Sensor, % LEL Combustible Gasses 02542-005 S

RECON/B SERIES ENMET 13 8.0 WARRANTY ENMET warrants new instruments to be free from defects in workmanship and material under normal use for a pe

PO Box 979 680 Fairfield Court Ann Arbor, Michigan 48106-0979 734.761.1270 Fax 734.761.3220 Returning an Instrument for Repair ENMET instrument

Repair Return Form Mailing Address: ENMET PO Box 979 Ann Arbor, Michigan 48106 Phone Number: 734.761.1270 FAX Number: 734.761.3220 S

Table of Contents 1.0 INTRODUCTION...

RECON/B SERIES ENMET 1 1.0 Introduction The RECON/B SERIES is a portable-single gas detector for detection of combustible or toxic gases. It is

RECON/B SERIES ENMET 2 2.0 Features 2.1 RECON/B SERIES Features See Figure 1 for location of features: FEATURE DESCRIPTION 1 Visual Alarms Red i

RECON/B SERIES ENMET 3 LCD, DISPLAY NUMBER FUNCTION 1 Battery 2 Lock 3 sound 4 vibration 5 Alarming conditions 6 Warning or the maximum level

RECON/B SERIES ENMET 4 4.0 Operation 4.1 Activation of the RECON/B SERIES To activate the detector, press the POWER button and hold for 3 seco

RECON/B SERIES ENMET 5 4.3 Checking RECON/B SERIES Status To activate the detector, press the POWER button and hold for 3 seconds. When the RE

RECON/B SERIES ENMET 6 4.5 Alarms When alarming continuously, you can press SET button to turn off the audible alarm and vibration when the a

RECON/B SERIES ENMET 7 Time error In this condition, the device will try to renovate it by itself. If succeeded, after start-up, it enters into