Enmet OMNI-4000 Manual de usuario Pagina 33
- Pagina / 72
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
OMNI-4000 S/N 6705 and above ENMET Corporation
27
Alarms Triggered
• Intermittent audible alarm
• General alarm indicator lamp blinking
• One or more alarm indicator lamps blinking
• Display of an explanatory message in the appropriate display quadrant
• The reading of the channel in alarm is frozen at the maximum recorded value
Action
• Find out which channel or channels are in alarm by means of the channel alarm indicator lamps. See Figures 2-
17, 2-18, and 2-19. The corresponding quadrant alternately displays "ALARM", the reading and the type of gas.
• Refer to the paragraph below concerning the type of gas:
"LEL Alarm" paragraph for an explosive gas channel (%LEL)
"Oxygen Alarm" paragraph for an oxygen channel
"Toxic Gas Alarm" paragraph for a toxic gas channel
LEL A
LARM (Figure 2-17)
OMNI-4000 without oxygen sensor
• Be careful, explosive gas present
• Press ENTER to acknowledge the buzzer and reactivate the display
OMNI-4000 with oxygen sensor and Over Range option
• Be careful, explosive gas present
• Press ENTER to:
Attempt to acknowledge the buzzer. Acknowledgement is possible if
he reading is below 10%LEL.
And reactivate the display
O
XYGEN ALARM (Figure 2-18)
The oxygen reading must be between the two thresholds for oxygen abundance and oxygen deficiency. The alarm is
triggered whenever the reading is not between the High Alarm and Low Alarm thresholds.
• Leave the area as quickly as possible. Excess and lack of oxygen are both dangerous
• Press ENTER to acknowledge the buzzer and reactivate the display
T
OXIC GAS ALARM (Figure 2-19)
Three types of reading can trigger the toxic gas alarm:
• Exceeding of the maximum instantaneous permissible value
• Exceeding of the permissible TWA (Time Weighted Average)
• Exceeding of the permissible STEL (Short Term Exposure Limit)
In each of these cases, a specific message cyclically replaces the reading in the appropriate channel:
"ALARM" whenever the maximum permissible instantaneous value has been exceeded. The reading is frozen in
order that the operator can see the maximum value recorded.
"STEL AL" when the Short Term Exposure Limit has been exceeded (sliding mean of 15 minutes)
"TWA AL" when the Time Weighted Average has been exceeded (sliding mean over 8 hours)
Proceed as follows:
Leave the area as quickly as possible. High instantaneous or accumulated excesses (STEL or TWA) are equally
dangerous
Press ENTER to acknowledge the buzzer and reactivate the display
- OMNI – 4000 1
- S/N 6705 and Above 1
- Operation and Maintenance 1
- Table of Contents 3
- List of Figures and Tables 5
- Introduction 7
- Of This Instrument 7
- 1.0 General Description 10
- 1.5 Gas Detection 11
- Programming 11
- 1.6 Sensor Readings 12
- 1.7 Alarms 13
- 1.7.2 Fault Alarms 14
- 1.7.1 Gas Alarms 14
- ENTER switch 15
- 1.9 Data Stored 16
- 1.9.2 Data Available 17
- 1.9.3 Length of Data Storage 17
- Removable 18
- Battery Pack 18
- Lithium Batter 18
- 1.13 Intrinsic Safety 19
- 2.0 Operation 21
- Stationary Beacon Mode 23
- 2.2 Starting Up 23
- Figure 2-5: Start-up Display 24
- Example: 24
- 2.2.4 Start-Up with Auto Set 25
- 2.3 Lighting 26
- 2.4.1 Date and Time 28
- 2.4.3 Minimum-Maximum 28
- 2.4.5 STEL and TWA 29
- 2.5 Alarms 30
- LARM (Figure 2-17) 33
- XYGEN ALARM (Figure 2-18) 33
- OXIC GAS ALARM (Figure 2-19) 33
- 2.6 Turning the OMNI-4000 Off 34
- Example of Display countdown: 34
- 2.7 Recharging the Battery 34
- 2.8 Printing the Histograms 36
- 25 Pin Sub D Plug, Right 37
- 2.9 Interference Gas Response 39
- 3.2 The Maintenance Menu 41
- 3.3.2 For an Oxygen Channel: 46
- 3.3.3 For a Toxic Gas Channel 47
- The calibration cover 49
- Humidifier 52
- Used with BRH Sensor 52
- Top View of Humidifier 52
- Channel Zero Potentiometer 56
- 4.0 Appendixes 63
- AC dual rate charger 65
- 5.0 WARRANTY 66
- PO Box 979 69
- 680 Fairfield Court 69
- 734.761.1270 Fax 734.761.3220 69
- Repair Return Form 71
Relacionado con productos y manuales para Instrumentos de medición Enmet OMNI-4000
(26 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.087 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales